|
SAVE on
your utility
bills
Water
Heater Application
Reduces Heating Costs
- Easy to Install
- Easy cut-to-fit
- Fits Gas or Electric Units
- Contains No Fiberglass
Single Bubble/Double
Foil may be used as a wrap for hot water heaters,
pipes, metal and commercial buildings, stud walls,
roofing systems, basements and crawl spaces.
Includes Reflective Jacket and
necessary Foil Tape
$59.00
Free
Shipping
Single
Bubble White Radiant Barrier Water Heater Jacket works
by reflecting heat back into the water heater. The jacket
can be installed in minutes, and fits both gas
and electric units. A Single Bubble White Radiant Barrier
Water Heater Jacket can save up to 20% on hot water
heating costs (or about $4.00 per
month)!
Single
Bubble/Double Foil may be used as a wrap for hot
water heaters, pipes, metal and commercial buildings,
stud walls, roofing systems, basements and crawl
spaces.
Same day shipping if
ordered by mid day
Use contact form or CALL
Today for more information and pricing
877-896-2780
Improve your
power factor save energy
costs! |
Full
Instructions
Your Kit Will Include:
| Material List: |
(1) Innovative Insulation Reflective
Blanket
(1) Reflective Aluminum Tape for
Seams |
| Tools Required: |
Felt Tip Marker, Tape Measure or Ruler,
Scissors or Utility Knife |
Important Warnings
- The cover must NEVER RESTRICT AIRFLOW into the
Burner Area on a gas water heater (located at the
bottom of the tank).
- Do not cover or restrict top venting hood,
pressure relief valve (located on the top or side of
tank), or burner access cover.
- On electric tanks, do not put material over access
cover or the wiring connection box.
Directions
| Step 1: |
Wrap water heater starting at the top of tank
and cut foil to overlap two (2) inches. Put
white side of material toward tank. Continue
down tank as stated above. |
| Step 2: |
Use remaining pieces to fabricate top circle.
Make two semi circles slightly larger than the
tank. Cut access holes for water intake, water
outlet, draft diverter and any other protruding
valves or pipes. NOTE: When two halves of top are
placed on the heater, sides should extend about
1/2" beyond the edge of the water heater all the
way around. |
| Step 3: |
Put top pieces on water heater and tape seams
with foil tape. |
| Step 4: |
Fit the jacket loosely around the heater. Tape
the large piece to top piece. Then tape the
vertical seam. NOTE: CUT OPENING IN THE JACKET TO
ALLOW EXPOSURE OF THE POP OFF VALVE PIPE. |
| Step 5: |
Cut out holes for burner cover, controls,
drain, etc. Make hole about two (2) inches larger
than access opening to allow plenty of airflow
around burner area. |
| NOTE: |
When installed properly, the jacket should
hang loosely, and slightly extended away from the
sides of the water heater. |
| Optional: |
You may want to tape jacket to tank around
access hold. This will keep edges
secure. |
|
